PRODUCT CATEGORY
CONTACT US

Tel: 0086-574-8725 8573
Fax: 0086-574-8389 1601
Mobile: 0086-13823656259
Email: ez-tech@yingtai-china.com
  
News&events
Dust Cap Is Very Important
author: Nancy.Miao [ 2012-12-19 16:40:02 ]

A dustcap is a small cover used on the valve stem of a bicycle or car tire to prevent dust or other small particles from entering the valve and damaging it. The dust cap also forms a pressure seal, helping to prevent deflation of the tire due to slight gas seepage past the tire valve.Dustcaps are usually made from Plastic but may occasionally be made of metal: Brass. The dust cap is internally threaded and is secured by screwing it onto the end of the valve stem. To prevent corrosion due to Electrolysis and malfunction of the electronics in a direct TPMS and avoid costly repairs, metal valve caps without insulating plastic linings should not be used on direct-TPMS-equipped tire valve stems.

A dust cap may also refer, on a bicycle, to the crank arm bolt cover. It is usually a piece of metal or plastic that, on the crank arm, is snapped or screwed into the threaded counterbore, which houses the bolt that holds the crank arm to its axle, the bottom bracket spindle. The dust cap serves to protect the threads (on the inside of the counter bore), which are used with a crank arm puller to remove the crank arm from the spindle. It is also possible for the crank arm to squirm on the bottom bracket spindle, causing the crank arm nut/bolt to become loose, leading to the nut/bolt working its way out of the bottom bracket spindle. The dust cap limits the amount of dangerous loosening that can occur.

A dust cap may also refer, on a bicycle, to the metal ring that covers the bearings in a cup-and-cone ball-bearing hub set. These types of dust caps, being press-fit, are difficult to remove with bending or damaging them. It is suggested to press them out from the other side of the hub using a screw driver. In this role the dust cap reduces the dust that enters the bearing races, and extends service intervals.

Here is the link for our Dust Cap: http://www.yingtai-china.com/index.php/product/Valve%20cap.html

Standard bore and Large bore. Please call us or leave us message when you need it. Also, it could be with different logo on its head.

Thank you.

 

 

 

Copyright © All rights reserved by EZ TECH INDUSTRY & TRADING COMPANY LIMITED